TBT BSN | Notification

Notification Detail :: G/TBT/N/TTO/139

Notification No.

Notification Type

Notifying Member

Date of Notification

Final Date for Comments

Days to Final Date

Title

Electrical lighting products - Compulsory requirements

Objective

Consumer information, labelling (TBT); Prevention of deceptive practices and consumer protection (TBT); Protection of human health or safety (TBT); Protection of the environment (TBT); Quality requirements (TBT); Harmonization (TBT)

Product Covered

Electric filament or discharge lamps, incl. sealed beam lamp units and ultraviolet or infra-red lamps; arc lamps; light-emitting diode "LED" light sources; parts thereof (HS code(s): 8539)

Document Notification

Link to ePing

HSCODE

8539 - Electric filament or discharge lamps, incl. sealed beam lamp units and ultraviolet or infra-red lamps; arc lamps; light-emitting diode "LED" light sources; parts thereof

ICSCODE

29.140 - Lamps and related equipment

Keywords

Specific Regions

Description

This National Standard specifies safety requirements for all electrical lighting products for use in Trinidad and Tobago, including but not limited to, fluorescent lamps, tungsten filament lamps, light-emitting diode lamps (LED), seasonal and holiday decorative products and luminaires. It also specifies labelling information to be placed on the electrical lighting products as well as information to be placed on the packaging for such products.This standard applies to electrical lighting products intended for use at either of the following nominal supply voltages:a)     115 volts, with a relative tolerance of ± 6 %; orb)     230 volts, with a relative tolerance of ± 6 %.NOTE    These nominal supply voltages have been declared by the Trinidad and Tobago Electricity Commission (T&TEC) in their publication entitled “Wiring for Light and Power”. The Electricity Supply Rules made under Section 15 of the Electricity (Inspection) Act Chapter 54:72 provides for variations of six percent above or below the declared voltages.This standard does not apply to electrical lighting products designed exclusively for industrial purposes or electrical lighting products intended to be used in locations where special conditions prevail, e.g. the presence of a corrosive or explosive atmosphere (caused by dust, vapour or gas).This standard does not apply to electrical appliances, accessories or components.

Notified Document

1:File here

Link to Notification

EN:File here

Status Active

No	#	Comment By	Title	Comment Date	File

Back

Notification Detail :: G/TBT/N/TTO/139

Link to ePing

App Settings