TBT BSN | Notification

Notification Detail :: G/TBT/N/ISR/1297

Notification No.

Notification Type

Notifying Member

Date of Notification

Final Date for Comments

Days to Final Date

Title

SI 4466 part 5 – Steel for the reinforcement of concrete: Cut and bent bars and fabrics

Objective

Protection of human health or safety (TBT); Prevention of deceptive practices and consumer protection (TBT)

Product Covered

Cut and bent steel bars and fabric for the reinforcement of concrete

Document Notification

Link to ePing

HSCODE

7213 - Bars and rods of iron or non-alloy steel, hot-rolled, in irregularly wound coils; 7214 - Bars and rods, of iron or non-alloy steel, not further worked than forged, hot-rolled, hot-drawn or hot-extruded, but incl. those twisted after rolling (excl. in irregularly wound coils); 7227 - Bars and rods of alloy steel other than stainless, hot-rolled, in irregularly wound coils; 7228 - Other bars and rods of alloy steel other than stainless, angles, shapes and sections of alloy steel other than stainless, n.e.s.; hollow drill bars and rods, of alloy or non-alloy steel; 7314 - Cloth, incl. endless bands, grill, netting and fencing, of iron or steel wire, expanded metal of iron or steel (excl. woven products of metal fibres of a kind used for cladding, lining or similar purposes)

ICSCODE

77.140.15 - Steels for reinforcement of concrete; 91.080.40 - Concrete structures

Keywords

Specific Regions

Description

Revision of the  Mandatory  Standard  SI  4466  part  5  dealing with steel for concrete reinforcement.  This draft standard revision adopts the British Standard BS 8666: 2005, including its Incorporating Amendment no. 1 of January 2008, and therefore is significantly different from the old standard. The major differences between the old version and this new revised draft standard are as follows:Expends Table 3 dealing with the standard shapes and adds details for measurements and options for bending;Updates Table 4 dealing with the standard fabric types and stock sheet size;Deletes Section D dealing with the approval of batches;Changes the informative Annex A dealing with the third-party certification and batch testing.The following sections of this draft revision will be mandatory after the entry into force:Section 1: Scope;Section 2: Normative references;Section 3: Terms, definitions and symbols;Section 4: Notation;Section 6: Form of bar or fabric label;Section 9: Allowable deviations on cutting and bending dimensions;Section 10: Radius of bending;Section 11: Bending of fabric reinforcement.

Notified Document

1:File here

Link to Notification

EN:File here

Status Active

No	#	Comment By	Title	Comment Date	File

Back

Notification Detail :: G/TBT/N/ISR/1297

Link to ePing

App Settings